Drawer Dishwasher
PRODUCT MODEL NUMBERS
PRODUCT DIMENSIONS
CUTOUT DIMENSIONS
KUDH03DT
Electrical:
120-volt, 60-Hz, AC-only, 15- or 20-amp fused electrical
supply. Use copper wire only. A time-delay fuse or circuit breaker and
separate circuit is recommended.
Water:
A hot water line with 20 to 120 psi (138 to 862 kPa) water
pressure. Water temperature must be 120°F (49°C) at dishwasher. Use
flexible stainless steel braided fill line (1/2" [1.3 cm] minimum plastic
tubing not recommended).
Drain Requirements:
Use the new drain hose supplied with your
dishwasher. If this is not long enough, use a new drain hose with
maximum length of 12 ft (3.7 m) that meets all current AHAM/IAPMO
test standards, is resistant to heat and detergent, and fits the 1" (2.5 cm)
drain connector of the dishwasher.
Connect drain hose to waste tee or disposer inlet above drain trap in
house plumbing and 20" (50.8 cm) minimum above the floor. It is
recommended that the drain hose either be looped up and securely
fastened to the underside of the counter, or be connected to an air gap.
Use a drain air gap if the drain hose is connected to house plumbing
lower than 20" (50.8 cm) above the subfloor or floor.
Use 1/2" (1.3 cm) minimum I.D. drain line fittings.
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10185042
08-27-08
®
23
³⁄₈
"
(59.4 cm)
19
¹⁄₄
"
(48.9 cm)
1
¹⁄₂
"
(3.8 cm)
24"
(61 cm)
33
³⁄₄
"
(85.7 cm)
23
¹⁄₂
"
24"
(61 cm)
33
³⁄₄
"
(85.7 cm)
(59.7 cm)
NOTE:
All holes should be drilled at 1½" (3.8 cm) diameter.
A. Choose left-hand or right-hand drain and water connection route.
B. Choose left-hand or right-hand electric connection route.
A
B
25"
(63.5 cm)
1/2"
(1.3 cm)
8"
(20.3 cm)
PREFERRED UTILITY AREA
