9
9
9
9
9
9
Freezer Drawer
Remove Drawer Front
1.
Open the freezer drawer to its full extension.
2.
Loosen the two top screws that fasten the drawer front to the
drawer glides. The two screws (one on the left-hand side and
one on the right-hand side) are located inside the drawer front.
3.
Lift up on the drawer front to release the plastic studs from the
drawer glide bracket slots.
4.
Slide the drawer glides back into the freezer.
Replace Drawer Front
1.
Pull out the freezer drawer glides to their full extension.
2.
Holding the drawer front by its sides, align the two plastic
studs, located at the bottom, inside the drawer front, with the
drawer glide bracket slots.
NOTE:
It helps if one person holds the drawer glides steady
while another person aligns the drawer front and inserts the
studs into the slots.
3.
Replace and tighten the two screws at the top of the drawer
front (one on the left-hand side and one on the right-hand
side).
Final Steps
1.
Plug into a grounded 3 prong outlet.
2.
Reset the controls. See “Using the Control(s)” and
“Temperature Controlled Exterior Drawer.”
3.
Return all removable parts and the food to the drawers.
Align Doors and Drawers
Once the doors and drawer fronts are replaced on the refrigerator,
you may notice that the doors appear angled or that they are no
longer level. Both the refrigerator doors and refrigerated drawers
are adjustable.
Align Refrigerator Door
Tools Provided:
¹⁄₈
" hex key
1.
Keeping both refrigerator doors closed, pull out the right-hand
refrigerated drawer. Locate the bottom hinge pin of the
refrigerator door. The alignment screw is inside the bottom
hinge pin.
2.
Insert the short end of the
¹⁄₈
" hex key (packed with the Door
Handle Installation Instructions) into the bottom hinge pin until
it is fully engaged in the alignment screw.
■
To raise the door, turn the hex key to the right.
■
To lower the door, turn the hex key to the left.
3.
Continue to turn the alignment screw until the doors are
aligned.
A. Drawer glide bracket slots
A. Drawer front screw
B. Drawer front plastic stud
A
A
B
A. Bottom hinge pin
B. Turn to the right to raise.
C. Turn to the left to lower.
D.
¹⁄₈
" Hex key
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
A
B
C
D
