KitchenAid KHWS01PMT / WH, Technical Education

Page: 55 / 86

4-25
12. Remove the three 1/2
″
hex-head bolts
from the rear counterweight and remove
the weight.
13. Remove the two rear shock absorbers
from the tub. To remove a shock absorber:
a) Pry the locking tab down with a small
screwdriver.
10. Loosen the clamp and pull the end of the
drain hose from the tub.
11. Remove the three T-20 torx screws from
the drive motor shield and remove the
shield from the bottom of the tub.
Drain Hose
Motor Shield
Rear Counterweight
b) Twist the top section so the tabs align
with the slots in the tub.
c) Lower the top of the strut down through
the slot, and rotate the shock absorber
against the floor of the cabinet.
Locking Tab
Align Tabs
With Slots
Continued on the next page.