7
Installation
Instructions —
Portable Outdoor
Grill
Excessive Weight Hazard
Use two or more people to move
and install grill.
Failure to do so can result in back
or other injury.
WARNING
1.
Move grill into desired outdoor
location.
2.
Open the hood.
3.
For models equipped with
rotisserie, remove the rotisserie’s skewer
from the grill.
4.
Carefully lift off grill grates and set
aside.
sear plate
5.
Remove sear plates and set aside.
burner
remove
tiedowns
6.
Remove tiedowns from burners
and warming shelf.
7.
Reinstall sear plates. Make sure
sear plates are resting on pins.
8.
Open cabinet doors and remove
L.P./propane gas tank.
9.
Make gas
connections.
L.P./propane
(supplied): The
20 lb. L.P. tank is
located in the
compartment below grill. Remove tank
and take to an authorized dealer to be
filled. Reinstall tank and screw the hose/
regulator assembly to tank as shown.
The pressure regulator and hose
assembly supplied with the grill must be
used. Replacement pressure regulator
and hose assembly specific to your
model, is available from your outdoor grill
dealer.
If converting to natural gas, see
conversion kit requirements and “Gas
supply requirements” section. Follow
instructions included with kit.
hose/regulator
assembly
10.
Turn on the gas supply. Wait a
few minutes for gas to move through the
gas line.
Test for gas leaks.
Test all connections by brushing on an
approved non-corrosive leak-detection
solution. Bubbles will show a leak.
Correct any leak found.
11.
Go to “Checking and adjusting
the burners” section.
warming
shelf
remove
tiedowns
pins
