![background image](http://html.mh-extra.com/html/kitchenaid/kfgg504kps/kfgg504kps_owners-manual_198254012.webp)
12
4.
Drill two 1/8" (3 mm) holes that correspond to the bracket
holes of the determined mounting method. See the following
illustrations.
Floor Mounting
Rear position
Front position
Diagonal
(2 options)
Wall Mounting
5.
Using the Phillips screwdriver, mount anti-tip bracket to the
wall or floor with the two #12 x 1
5
⁄
8
" (4.1 cm) screws provided,
mount anti-tip bracket to the wall or floor.
6.
Move range close enough to opening to allow for final gas and
electrical connections. Remove shipping base, cardboard or
hardboard from under range.
7.
Move range into its final location, making sure rear leveling leg
slides into anti-tip bracket.
8.
Move range forward onto shipping base, cardboard or
hardboard to continue installing the range using the following
installation instructions.
Make Gas Connection
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to propane, have a qualified person make
sure gas pressure does not exceed 14
ʺ
(36 cm) water
column.
Examples of a qualified person include: licensed heating
personnel, authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
Typical flexible connection
1.
Apply pipe-joint compound made for use with propane gas to
the smaller thread ends of the flexible connector adapters
(see B and G in the following illustration).
2.
Attach one adapter to the gas pressure regulator and the other
adapter to the gas shut-off valve. Tighten both adapters, being
certain not to move or turn the gas pressure regulator.
3.
Use a 15/16" (2.4 cm) combination wrench and an adjustable
wrench to attach the flexible connector to the adapters.
IMPORTANT:
All connections must be wrench-tightened. Do
not make connections to the gas regulator too tight. Making
the connections too tight may crack the regulator and cause a
gas leak. Do not allow the regulator to turn when tightening
fittings.
A.
Gas pressure regulator
B.
Use pipe-joint compound.
C. Adapter (must have 1/2"
(1.3 cm) male pipe thread
D. Flexible connector
E.
Manual gas shutoff valve
F.
1/2" (1.3 cm) or 3/4" (1.9 cm)
gas pipe
G. Use pipe-joint compound.
H. Adapter