25
3. Remove one end cap by loosening the nuts and sliding the
end cap off.
4. Slide the custom panel into the top grille channel and
reattach the end cap.
5. Replace the top grille in the cabinet side trims and pull the
panel down slightly to lock it into place.
Adjust Door(s)
Door Alignment (36" [91.4 cm] Models)
1. Loosen, but do not remove, the four Torx
®†
27 flat-head
mounting screws and the two
¹⁄₄
" hex-head mounting screws
in the top hinge.
2. Adjust the top hinge of the door to align it.
3. Tighten the Torx
®†
27 flat-head mounting screws to a torque
of approximately 100 inch-pounds (11.3 Nm).
4. Tighten the
¹⁄₄
" hex-head screws.
Door Height Adjustment (42" [106.7 cm] Models)
Use the following steps to adjust the door height, up or down,
after the refrigerator has been leveled.
NOTE: Adjust the right door to the position of the left door first. If
it is necessary to adjust the left door, you must make sure that the
hinged center rail located on the left-hand door does not drag
when closing the door.
1. Open the freezer drawer. Remove the locking plate screw
from the bottom side of the refrigerator door hinge using a
¹⁄₄
" open-end wrench.
2. Remove the locking plate as shown.
A. Bottom rail
B. Nuts
C. End cap
D. Top rail
A. Custom panel
A. Top grille
B. Cabinet side trims
C
B
A
D
A
B
B
A
A. Torx
®†
27 flat-head mounting screws
B.
¹⁄₄
"
hex-head mounting screws
A. Bushing
B. Locking plate
C. Locking plate screw
†®TORX is a registered trademark of Saturn Fasteners, Inc.
A
B
B
C
A
