17
4. After adjusting, check doors to make sure they are even at
the top and bottom. If doors are not even, continue to turn
the bushing to adjust door height.
5. Replace locking plate.
6. Turn bushing slightly to align the hinge and locking plate
screw holes.
7. Replace door stop screw and tighten.
8. Make final recheck to make sure doors are aligned and even.
Door Swing Adjustment
1. Check that the refrigerator door can open freely. If door
opens too wide, remove the door stop screw from the bottom
hinge. Hold door open to a position that is less than 90°.
2. Replace door stop screw in bottom hinge and tighten screw.
Side by Side:
Replace door stop screw in the 110° or 90° door stop
position.
1. 130° position
2. 110° position
3. 90° position
Bottom Mount:
Replace door stop screw in the 90° door stop position.
1. 130° position)
2. 90° position
If door does not clear countertop after door has been adjusted,
countertops may have to be mitered.
Install Decorative Top Panel
Adding a Decorative Panel to the Top Grille Assembly
1. Grasp both ends of the top grille assembly.
2. Push top grille assembly frame straight up, then pull straight
out. Lay assembly on soft surface.
3. Remove nuts and side trim from right side of the top grille
assembly frame. Insert decorative panel into frame. Reattach
side trim and nuts.
1. Nuts
2. Top grille side trim
4. Reattach top grille assembly by inserting hooks (located on
the back of the top grille) into the slots on the side trim. Pull
panel down slightly to lock into place.
1. Top Grille
2. Cabinet Side Trim
IMPORTANT: KitchenAid is not responsible for the removal or
addition of molding or decorative panels that would prevent the
refrigerator from being serviced.
1
2
1
2
2
2
1
