3
English
Assembling Your Bowl-Lift Mixer
To Attach Bowl
1. Turn speed control “O”.
2. Unplug Stand Mixer or disconnect
power.
3. Place bowl-lift handle in down
position.
4. Fit bowl supports over locating pins.
5. Press down on back of bowl until
bowl pin snaps into spring latch.
6. Raise bowl before mixing.
7. Plug into proper electrical outlet.
To Raise Bowl
1. Rotate handle to straight-up
position.
2. Bowl must always be in raised,
locked position when mixing.
To Lower Bowl
1. Rotate handle back and down.
To Remove Bowl
1. Turn speed control “O”.
2. Unplug Stand Mixer or disconnect
power.
3. Place bowl-lift handle in down
position.
4. Remove flat beater, wire whip, or
dough hook.
5. Grasp bowl handle and lift straight
up and off locating pins.
To Attach Flat Beater,
Wire Whip, or Dough Hook
1. Turn speed control “O”.
2. Unplug Stand Mixer or disconnect
power.
3. Slip flat beater on beater shaft.
4. Turn beater to left, hooking beater
over the pin on shaft.
5. Plug into proper electrical outlet.
To Remove Flat Beater,
Wire Whip, or Dough Hook
1. Turn speed control “O”.
2. Unplug Stand Mixer or disconnect
power.
3. Press beater upward and turn
right.
4. Pull beater from beater shaft.
Stand Mixer Speed Control
The Soft Start™ feature minimizes
splash-out by starting the mixer
slowly before increasing to the
selected speed. To further reduce the
potential for splash-out, always begin
mixing using Speed 1 (STIR speed),
then gradually move to higher speeds
as needed. See page 7 for “Speed
Control Guide.”
Auto-Reset Motor Protection
If the Stand Mixer stops due to
overload, slide the speed control lever
to “O”. After a few minutes, the
Stand Mixer will automatically reset.
Slide the speed control lever to the
desired speed and continue mixing.
If the unit does not restart, see
“When You Need Service” on
page 12.
Pin
10
2
1
4
6
8
O
Raise
