Before you start...
Tools needed for installation:
This is the safety alert
symbol.This symbol alerts
you to hazards that can kill
or hurt you and others. All safety
messages will be preceded by the
safety alert symbol and the word
“DANGER” or “WARNING”. These
words mean:
You can be killed or seriously
injured if you don’t follow
instructions.
DANGER
Your safety and the safety of
others is very important.
We have provided many important
safety messages in this manual and
on your appliance. Always read and
obey all safety messages.
All safety messages will identify the
hazard, tell you how to reduce the
chance of injury, and tell you what
can happen if the instructions are
not followed.
You will be killed or seriously
injured if you don’t follow
instructions.
Parts supplied:
WARNING
2
Important: Observe all governing
codes and ordinances.
Proper installation is your responsibility.
Have a qualified technician install this
oven.
Oven location should be away from
strong draft areas, such as windows,
doors and strong heating vents.
Cabinet opening dimensions that are
shown must be used. Given dimensions
provide minimum clearance.
Recessed installation area must provide
complete enclosure around the recessed
portion of the oven.
Electrical ground is required. See
“Electrical requirements.”
Electrical supply outlet should be
located in the rear wall on the lower right
side of the cutout or in an adjacent
cabinet. The outlet must be recessed. If
the electrical outlet is located in an
adjacent cabinet, provide a 1-3/8" dia.
minimum power supply cord plug
clearance hole in the back of the cutout or
support surface.
Oven support surface MUST be solid,
level and flush with bottom of cabinet
cutout.
There is no provision to level the oven
after it has been installed. If the
installation is not level, the door may
slide open or not seal tightly allowing
heat to escape resulting in poor oven
performance.
Phillips
screwdriver
Copies of the standards listed may be obtained
from:
* National Fire Protection Association
One Batterymarch Park
Quincy, Massachusetts 02269
It is the customer’s responsibility:
To contact a qualified electrical installer.
To assure that the electrical installation is
adequate and in conformance with
National Electrical Code, ANSI/NFPA 70
— latest edition*, and all local codes and
ordinances.
2 screws