KisanKraft
®
Maize Harvester
KK-MCH-01D
: +91.80. 6835 7800
Page 9 of 20
Inspection & Adjustment
The machine has been adjusted and calibrated strictly before leaving the factory. However, it is
necessary to check and adjust various parts before the first operation or anytime if necessary.
1.
Daily inspection
Warning
Before operating, you must fill machine oil into engine oil cup of air filter, gear box of walking case,
gearbox of the harvester. Please note that oil is not filled while leaving factory. Following this, the
operator should check machine oil often. While working if machine oil is found insufficient or if it is not
clean, then refill/ change it immediately, else the machine will be seriously damaged.
1.1 Inspect engine oil in engine, the regular volume is
0.7L.
•
Keep the machine on a flat surface.
•
Move the oil level gauge, clean it.
•
Put back it into hole again, do not turn.
•
Move it out again, check the oil level, the
normal position is at the middle of mark. As
shown in the right picture.
1.2 Inspect the engine oil in air filter, if there is no
suitable volume of engine oil in the oil type air
filter, it will damage the engine.
The regular level is
near the mark of “oil
level”.
1.3 Inspect the engine oil in gearbox of walking case, the regular volume is 1.8L. Procedure is same
as mentioned above in 1.1: fill engine oil in engine.
1.4 Inspect the engine oil in gearbox of harvesting, the regular volume is 2.2L.
•
You can remove the cover, turn tightly after filled.
Note: there is no gauge here, just fill the volume as required.
•
Inspect the control part such as control knobs, clutches, shift level, etc. Ensure they all are
working reliably
•
Inspect screw bolts, parts of joint, ensure they all are fastened tightly.
