KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-406D
KK-IC-406D (Electric Start)
This warranty is null & void, if you fail to register the warranty with
KisanKraft by sending the KisanKraft Copy with dealer’s stamp.
: +91.80. 6835 7800
Page 18 of 56
•
If the engine gives out black smoke continuously, it is because the engine is
overloaded. The belt pulley of the engine or that of the powered equipment must be
adjusted.
•
Pay attention to the following points when the engine is running:
i.
Whether there is abnormal sound and vibration?
ii.
Whether the exhaust is normal?
iii.
Whether the engine gives out white or black smoke continuously?
If any of the above phenomena is detected, stop the engine immediately and contact the
nearby dealer.
Methods of Starting the Agricultural Inter-cultivator
Starting by Hand:
1.
Open fuel switch.
2.
Put engine speed lever in the start position
3.
Lock Auto-cut off switch.
4.
Hold recoil starter handle.
5.
Pull the starting handle slowly until you feel the resistance, then release it slowly.
6.
Push the decompression lever down by hand to no compression position. It will get
back automatically by itself after the engine gets started.
7.
Starting: hold the starting handle with two hands, pull the rope lightly until you feel
the resistance, then pull the rope fast with strength.
8.
If it is not easy to start the engine when the weather gets cold.
You could take down the refuel screw on the cylinder cover and fill in 2ml oil before starting.
Note
: Tighten the refuel screw on the cylinder cover except filling oil in order to avoid rain
and dust from getting into the engine and wearing causing damage to the engine.
Operation
(Note: breaking-in must be performed before the using the Inter-cultivator)
1.
Using a slow shift:
•
The left hand should grasp the clutch handle tightly making the clutch separated.
•
The right hand should pull the shift bar backwards, make sure the shift casing is
in the slow shift position, and observe whether it reaches the right position or not.
Then the right hand should grasp the right handle.
(Note: Do not grasp the reversing bar)
i.
Loosen the clutch handle gradually, the clutch will combine, and the Inter-
cultivator can run at a slow speed.
ii.
The right hand should increase the throttle properly so that the motor can
run at a speed of 5 km/h
2.
Using a fast shift:
•
The left hand should grasp the clutch handle tightly making the clutch separated.
•
The right hand pushes the shift bar forwards, make sure the shift casing is located
in the fast shift position, and observe whether it reaches the right position or not.
Then the right hand should grasp the right handle.
(Note: Do not grasp the reversing bar)
•
Loosen the clutch handle gradually, the clutch will combine, and the Inter-cultivator
can run at a fast speed.
•
The right hand should increase the throttle properly so that the motor can run at a
speed of 10 km/h.
3.
Using a reversing shift:
•
The left hand should grasp the clutch handle tightly making the clutch separated.
