KisanKraft
TM
HTP SPRAYERS
KK-18A2-18A3-22A3-30A3-45A3-80A3
KK-120A3-22B3-30B3-18CI3-22CI3-30CI3
KK-33CI3-53CI3-45CI3-80CI3120CI3
: www.kisankraft.com
: +91.80. 22178200
Page 10 of 20
OPERATING INSTRUCTIONS
1. Check every fastener and make sure that the sprayer and the motor/engine are
installed firmly on the frame.
2. Set both the pulleys in a straight line and the belt in an appropriate tightness.
3. All joints of the hoses must be tightened to prevent any leakage.
4. Before starting the motor/engine shut-off the cock (valve) Loosen the pressure
adjusting screw and pull the pressure adjuster to the top.
5. Start the motor to power the sprayer. Keep a proper RPM. Press the pressure
adjuster to the bottom.
6. Keep the pressure around 20-35 Kgs by adjusting the Pressure adjusting screw.
7. Open the cock (valve) to start spraying.
8. After the spraying is over, pull the pressure adjuster to the top and operate the
sprayer with fresh water to clean out the remaining chemicals
PUMP LUBRICATION
1. Replace the lubricating oil, after the sprayer has been used for the first 10 hours.
Next oil change should be after 40 hours. Afterwards oil should be changed
every 70 hours.
2. Drain away the dirty oil by opening the drain plug.
3. After the drain plug is screwed back, remove the oil inlet cover and refill fresh
SAE 20W-40 engine oil.
4. Keep the oil level at 2/3
rd
of the oil gauge.
5. Always fill the grease cups with grease. Screw on the grease cups, 2-3 cycles
every 2 hours of spraying.
