FarmBoy
®
Agricultural Reaper (Baffle Type)
FB-BC-8642 / 8652
FB-BC4-8636
: www.kisankraft.com
: +91.80.22178200
Page 16 of 36
Assembly
FB - BC4 - 8636
INSTALLING HANDLE:
Mount the handle 10 the shaft tube and clamp it at a location that is comfortable
to you.
INSTALLING DEBRIS GUARD:
This model pack with already installed debris guard.
Put the debris guard on the gear box, attach it with the screws and hardware
provided.
INSTALLING CUTTING HEAD:
This model pack with already installed cutting head.
While locking the gear shaft, by inserting the supplied tool into the upper holder on
the gear box, loosen and remove the hexagonal (left-handed)
Fit the line head assembly to the gear shah over the holders. Hand tighten it
securely.
FarmBoy
®
Agricultural Reaper (Baffle Type)
FB-BC-8642 / 8652
FB-BC4-8636
: www.kisankraft.com
: +91.80.22178200
Page 21 of 36
Adjusting the Line Length:
Your brush cutters is equipped with a semiauto type nylon line head that allows
the operator to advance the line without stopping the engine. When the line
becomes short, lightly tap the head on the ground while running the engine at
full throttle.
Each time the head is bumped, the line advance about 1 inch (25.4 mm). For
better effect, tap the head on bear ground or hard soil. Avoid bumping in thick,
tall grass as the engine may stall by overload.
Metal Blade Usage:
NOTE
:
Choose a suitable recommended cutting
attachment according to the object to be cut.
WARNING
When sharpening, removing, or reattaching
the blade, be sure to wear thick, sturdy
gloves and use only proper tools and
equipment to prevent injury.
1.
Check the bolt to fasten the blade
and be sure the bolt has no fault, and
no abrasion.
2.
Be sure that the blade and the holder
have been fastened according to
instruction and the blade turns
smoothly without abnormal noise.
WARNING
The rotating parts fastened incorrectly
may cause serious accident to the
operator.
Make sure that the blade is not bent,
warped, cracked, broken or damaged.
If you find any error to the blade,
discard it and change new one.
By using the harness, hang the unit on
your right side. Adjust the harness
length so that the cutting head may
become parallel to the ground
