Cymbal Pad
Cymbal Pad
Drum Module
Drum Pad
Drum Pad
Drum Pad
Hi-Hat control pedal
Kick Trigger
Watch your fingers when adjusting clamps. They may become pinched resulting in injury.
Be careful around pipe ends, inside the pipe and screw ends. Metal shavings, etc. May injure your fingers.
Before assembly, please make sure that all the items listed below are present.
[DRUM PADS] box
[BASS DRUM PEDAL] box
Drum Pad x 2
Kick Pad
Drum Key
Metal Rod x 2
Foot Pedal
Beater
Drumstick x 2
AC Adaptor
Instruction Manual
Assembly Instructions
Connecting Cable x 9
Metal Rod
[HI-HAT PEDAL] box
[DRUM MODULE] box
Hi-Hat control pedal
Drum module
Leg (R)
Center Pipe
Side Arm (R)
Side Arm (L2)
Connector
Holder clamp
Cymbal holder clamp
Holder clamp
Clamp
Holder clamp
Rubber Foots
Holder clamp
Connector
Pillar (R)
Connector
Connector
Cross pipe
Clamp
ASSEMBLY INSTRUCTIONS
Caution !
Inside This Package
[CYMBAL 3PCS] box
[DRUM PADS] box
[ACCESSORIES] box
Cymbal Pad x 3
Drum Pad x 2
Metal Rod x 2
Hexagon Key (5mm)
Cymbal holder (L) x 2
Cymbal holder (S)
Side Arm (L1)
Pillar (L)
Leg (L)
Cymbal holder clamp
Clamp
Rubber Foots
Cross pipe
Clamp
5 Attaching the Kick Trigger
[1] Attach the Rod to the holders.
[2] Attach the Kick Pedal to the Kick Pad.
[3] Tighten the wing screw on the Kick Pedal.
[4] Loosen the screw.
[5] Attach the Beater to the Kick Pedal
[6] Position the Beater from the center of the pedal, tighten the screw
4 Attaching the Drum Module
[1] Attach the Metal Rod to the Drum Module.
[2] Tighten the wing screw securely on the Drum Module.
[3] Attach the Metal Rod to the Holder clamp on the
Side Arm (L1) and adjust the position.
[4] Tighten the wind nut on the Holder clamp.
[1]
Wing screw
Metal Rod
[2]
[3],[4]
6 Setup Example
DD505 V003
[1]
[1]
[2]
[4]
[9]
Beater
[5]
[6]
[3]
