Basic
Basic
Basic
Restaurant
Charging the Battery
Before using your Remote
Control 2, you need to fully
charge the rechargeable
battery. To charge it, plug in
the charging cable as shown
to the right. Then plug the
other end into a power
outlet. During charging, the
bars in the battery meter will
be showing one, two and
three bars continuously.
When fully charged all three
bars will be shown continu-
ously.
NOTE!
Check with your hearing healthcare professional
to determine if your instruments have been pre-paired.
Instruments that have been pre-paired do not need to be
paired again.
Turning your Remote Control 2 ON and OFF
To turn your Remote Control 2 ON, slide the switch
on the side of the Remote Control 2 down to the ON
position.
A white ”I” icon will be visible on the base of the switch
and the display will turn on.
To turn your Remote Control OFF, slide the ON/OFF
switch up to the OFF position.
PAIRING YOUR REMOTE CONTROL
GETTING STARTED
Make sure the Remote Control 2 is fully charged and is
turned ON.
1.
Open the battery doors on
both hearing instruments
2.
Press the pairing button on
the Remote Control 2 to activate
the pairing mode, which will be
active for 20 seconds
3.
While in pairing mode, close
the battery doors on both hear-
ing instruments
A
B
DISPLAY SCREENS
4.
The Remote Control 2 will
search for the hearing instru-
ments.
5.
A successful pairing will
be indicated by an audible
melody played in both hearing
instruments, and shown in the
Remote Control 2 display with
active volume bars and pro-
gram “1”. You are now ready to
use the Remote Control 2!
Searching for both
hearing instruments
Connected to left hearing
instrument and searching
for right hearing instrument
Program 1 in left
and right hearing
instrument
Program 2 in left
and right hearing
instrument
Do not charge the Remote Control 2
while it is on your body.
400245240-CA Rev.A 13.07 RC2 Quick Guide.indd 2
26-07-2013 14:13:27
