WARNING!
READ, STUDY AND UNDERSTAND ALL WARNINGS BEFORE
USING. PERSONAL INJURY AND UNIT DAMAGE COULD OCCUR
IF INSTRUCTIONS ARE NOT FOLLOWED.
• DO NOT OVERLOAD DRAWERS.
• DO NOT open more than one loaded drawer at a time as tipping may occur.
• To prevent possible damage to the unit, close lid and make sure drawers and
doors are in the locked position before attempting to move.
• DO NOT stand on the product. Do not step in the drawers. You may fall which
may cause personal injury and/or property damage.
• DO NOT mount the product on truck bed or any other moving object.
• Apply brakes on swivel casters when not moving unit.
PARTS LIST
No.
Part Number
Description
Qty.
1
LT02-38
Handle
4
2
GB70-85
M6 x 55 Allen screw
8
3
LT02-38-03
Plastic cover cap
8
4
5AW
Allen Wrench
1
5
LT04-62
Top Box Key
2
6
LT04-61
Bottom Box Key
2
SAFETY INFORMATION
Save these instructions. For your safety, read, understand, and follow the instructions
provided with and on this product before use. Inspect after unpacking. Do not use if
broken, bent, cracked, or damaged parts (including safety labels). If the product appears
damaged in any way, operates abnormally or is missing parts, it should be removed from
service immediately and the manufacturer notified. Do not remove use stickers on
toolbox.
HANDLE ASSEMBLY
Tools required for assembly:
• 5mm Allen wrench (included)
• Small rubber mallet
1. Align each handle (#1) against
the side panel of toolbox.
2. Insert M6 x 55 Allen screw (#2)
provided. Tighten with 5mm Allen
wrench (#4 included).
3. Align plastic cover caps (# 3)
evenly over handle screw holes.
Using a small head rubber mallet,
tap plastic cover caps flush with
handle.
CARE INSTRUCTIONS
• Use a soft lint free cloth to clean
the finish regularly.
• Do not use corrosive chemicals
or abrasives on the finish.
• To ensure smooth drawer
movement, regularly lubricate
the top and bottom channels
of the inner drawer slides with
silicone grease spray.
Align Handle Here
Inner
Drawer
Slide
Middle
Drawer
Slide
Outer
Drawer
Slide
Lubricate Here
OPERATING INSTRUCTIONS
Note: DO NOT remove stickers adhered to the Toolbox.
Top Chest
1. To Lock: Close all drawers first. Close lid then turn key to the LEFT.
2. To Unlock: Turn key to the RIGHT. Open lid and pull drawer out.
Bottom Chest
1. To Lock: Close all drawers first. Turn key to the LEFT.
2. To Unlock: Turn key to the RIGHT. Pull drawer out.
To Remove Drawers:
1. To disassemble ball bearing
slides: Simultaneously press
the plastic lock springs up or
down to pull the inner drawer
slides out.
2. To reassemble: Insert the end
of the inner drawer slides into
the middle drawer slides.
Carefully slide into place.
Verify slides are securely
attached.
Inner
Drawer
Slide
Middle
Drawer
Slide
Outer
Drawer
Slide
OR
A1