When pressing the PTT button during the scanning
pause, the radio will transmit from the currently
working channel.
Last Called Channel:
When pressing the PTT
button, the radio will transmit from the last channel
that received a call.
Last Used + Currently Working Channel:
When
pressing the PTT button during the scanning, the
radio will transmit from the last channel that
transmits signals. When pressing the PTT button
during the scanning pause, the radio will transmit
from the currently working channel.
6.7.2 Nuisance Delete
During scanning, if a channel continually
generates unwanted noise or interference, you can
press the preprogrammed “Nuisance Delete” button
to remove the channel from the scan list
temporarily.
Note:
* The priority channel and the last channel in the
scan list cannot be deleted.
* Quit the scan mode and enter it again, the deleted
channel will be added to the scan list again.
6.8 Lone Worker
If lone worker function is enabled by PC software,
you can press the button set as lone worker to start
lone working. This mode is to ensure the safety of the
user while using the radio separately. The lone
w o r k e r t i m e r s t a r t s u p o n p r e s s i n g t h e
preprogrammed “Lone Worker” button. If the preset
lone worker time expires, the radio will make an alert
tone. If the preset remind time expires, the radio will
enter Emergency Mode and make alarm.
In the Lone Worker Mode, press the prepro-
grammed “Lone Worker” button again to quit Lone
Worker Mode.
In the Lone Worker Mode, press the prepro-
grammed “Lone Worker Reset” button (if a button is
designated as the lone worker timer reset
button) or any button (if any button is designated as
the lone worker timer reset button) to restart the lone
worker timer.
6.9 Emergency Alarm
Press the preprogrammed “Emergency Alarm”
button (the pressing time should be longer than the
debounce time of the emergency alarm switch) to
enter the Emergency Alarm Mode. You can give the
warning tone according to the programming software,
or send the background sound to your partner or the
system.
Press the preprogrammed “Emergency Alarm Off ”
button to quit the Emergency Alarm Mode, the radio
stops the alert and resumes normal operation.
7. Wired Clone Mode
If the wired clone function is enabled by PC
software, after entering the Wired Clone Mode, the
radio needs to be restart to return to user mode.
The operating steps go as follows:
1. Press and hold side button 2 while turning the
radio power on to enter Clone Mode. If the wired
clone function is disabled, the radio will enter User
Mode.
2. Connect the slave radio with the master radio
by a clone cable. Then switch on the slave radio.
3. Press side button 1 of the master radio, the
cloning starts. During the data transmission process,
the master radio will light red, and the slave radio will
light green. When the cloning is finished, the red LED
of the master radio will be off, and the slave radio will
restart automatically.
4. You can continue to clone data according to
step 3.
Note: The wired clone function can be enabled or
disabled by the PC programming software. Once the
wired clone function is disabled, the radio cannot
enter Wired Clone Mode.
13
14
