1.Insert the battery into
t h e b o t t o m o f t h e
transceiver until the
release catch on the
base of the transceiver
and locks the battery in
place.
2.To remove the battery ,
push back on the release
catch, then slide thepack
away from the transceiver.
INSTALLING THE ANTENNA
Holding the provided antenna at
its base, screw the antenna into
the connector on the top panel
of the transceiver.
Do not recharge the battery if it is already fully charged or there is
no low battery alarm .If do this, you will overcharge the battery
which may shorten its life or damage it.
After charging the battery fully, take it out from the Charger. If
having charged the battery, do not insert the battery back into the
changer again when the changer powers on, in that case, the
battery will become overcharged, thus the battery will be damaged.
Note:
Do not short the battery terminals or dispose of the battery by
fire.
Never attempt to remove the case from the battery.
Do not install the battery in dangerous conditions.The spark may
cause an explosion.
Note:
INSTALLING/REMOVING THE BATTERY
2
3
2
4