KIRAMI Premium Pearly, Instructions For Use Manual

Page: 28 / 88

© Kirami Oy, Finland
4 / 11
INSTRUCTIONS FOR USE: Kirami Premium Pearly
4. Notice that the end of the bolt shall enter the matching inlay in the valve.
5. Tighten the plug by turning the ring nut clockwise. Do not overtighten, only turn half a turn
at once until the water stops running.
6. The plug is opened by turning the ring nut counter clockwise and pulling it horizontally out
from the valve. If the plug seems to be stuck. Wait for a few minutes so the plugs shape
reverts. That way it will come out easier.
7. When water starts running, tighten the plug so it stays in.
Notice! Do not leave the plug tightened in for prolonged periods of time to ensure that it does not
get stuck in the valve body.
FIRE SAFETY
In case the tub is placed near buildings,
e.g. the edge of a terrace, ensure that
the chimney top is located away from
flammable materials. Remember to
check the distance both sideways and
vertically in order to avoid the risk of fire.
Local rules may vary.
There should be no flammable material
located in front of and below the
furnace. In practical terms, this means
that an area of incombustible material,
such as concrete, sand, or a metal plate,
is needed in front of the furnace. The
stove will not heat up above the water temperature as the stove is surrounded by a water jacket.
The chimney and door of the stove will heat up, however.
Fastening the stove
External MACU/CUBE stoves are supplied separately and the stove’s package includes model-
specific instructions and supplies for attaching them. Steady tanks do not have handles, as the
stove will be placed so close to the ground that it is easier to support from underneath. On an even
surface, there should be approx. 20 mm of space for the support below the stove. However, the
proper height of the support should always be checked at the installation site. Any drink trays /
cover plates can be attached to the stove’s handles with screws supplied with the stove. Ensure the
water-tightness and fastening to the tub. A model-specific drink stand / protective panelling series
attached to the stove are available.
Chimney
Be careful, the edges of the chimney are very sharp. Use protective gloves!
The chimney is delivered in a separate box and it consists of four parts
(picture on right) and it needs to be assembled. Remove the protective film
from the thermal protection and place the assembled chimney to the
chimney outlet of the stove.
28/88
09.04.2020