KIRAMI FinVision, Instruction Manual

Page: 19 / 25

19 / 25 INSTRUCTION MANUAL: Kirami FinVision sauna
Installing Narvi® electric heater
The Narvi
®
electric heater has already been attached to
the sauna in the factory. In order to use the sauna heater,
electricity must be connected to the sauna separately. The
end customer is responsible for connecting the sauna to
electricity. Only a qualified electrician can carry out the final
installation of an electric sauna heater. Electrician refers to a
person authorised to carry out electrical work or someone
working under the supervision of such a person. The valid
electrical safety regulations must be taken into account in
installing the sauna heater. In unclear cases, ask the local fire
or building authority for further instructions.
After installing the heater, put the sauna heater stones in
place. Placing the number of stones recommended in the
instructions into the sauna heater guarantees a better sauna
bath. For example, if an electric sauna heater only has a small
number of stones, the heater’s resistors may break. See the
manual included in the sauna heater package for more detailed instructions.
Using an electric sauna heater
THE SAUNA HEATER MUST NOT BE USED WITHOUT STONES. IF THE SPACE RESERVED FOR
STONES IS NOT FULL, IT WILL CAUSE A FIRE HAZARD!
Always check the sauna room before turning the sauna heater on. The sauna heater control switch
is located in the front of the bottom part of the heater.
General description
- The sauna heater can be turned on and off by pressing the I/O button
(toggle).
- The SET button is used for setting the following parameters: Preset
timing, power-on time and temperature. The settings are adjusted
with the +/- buttons. During set-up, a LED flashes to indicate the
parameter being set, with the respective value being displayed on the
screen.
- The power-on time and temperature settings remain in memory even
after a short power outage. After a longer power outage, the times are
reset to their default values. The preset timing will always be reset
after use.
- The On/Off LED is lit red whenever the heating elements are turned
on; at all other times it is lit green. During the preset time, the On/Off
LED is not lit.
On/Off indicator light Preset timing (yellow) Power-on time (green) Temperature (red)
SET
Attach electric heater’s control panel on
the back wall top of the lower bench.