© Kirami Oy, Finland
4 / 9
INSTRUCTIONS FOR USE: Kirami Comfort Family
© Kirami Oy, Finland
Fastening the stove
External CULT stoves are supplied separately and the stove’s package includes model-specific
instructions and supplies for attaching them. Family tanks do not have handles, as the stove will be
placed so close to the ground that it is easier to support from underneath. On an even surface,
there should be approx. 20 mm of space for the support below the stove. However, the proper
height of the support should always be checked at the installation site. Any drink trays / cover
plates can be attached to the stove’s handles with screws supplied with plates. Ensure the water-
tightness and fastening to the tub. A model-specific drink stand / protective panelling series
attached to the stove are available.
Chimney
Be careful, the edges of the chimney are very sharp. Use protective gloves!
The chimney is delivered in a separate box and it consists of four parts
(picture on right) and it needs to be assembled. Remove the protective film
from the thermal protection and place the assembled chimney to the
chimney outlet of the stove.
Grates
Cult stoves come with a cradle fireplace grate where a single wire tray grate is
installed. An air iron plate is placed on the top shelf to direct the circulation of air in
the upper part of the firebox. The plate in the upper part of the stove must not be
pushed too far so that it prevents the exhaust of the smoke.
It is prohibited to use the stove without these parts. Note that these parts wear
down over time and get bent and their form will change in use. You can purchase
new ones as spare parts when needed.
The first use
The water circulation of the stove shall be rinsed by letting plenty of water in from the pipe above,
so that any metal chips from grinding come out. Collect any trash by swiping it off the bottom of the
tub. When you fill the tub, check the fastening pipes of the stove for any leakages.
USE
When filling the tub, note the number of people because people entering the tub will displace the
water when they enter the tub. If there will be many people in the tub, leave the water surface at
the minimum.
In case you are using your own pump for filling the tub, remove the pumping hose after you have
filled the tub. Many pumps do not have a return valve to prevent the water discharge from the tub
when the pumps are switched off. Before filling the tub, check that the bottom plug of the tub is
closed, ensure that the plug is in place after you have some 10 cm of water in the tub.
Family tub has built in stairs to help getting in and out of the tub. This higher part of the stairs can
also be used as a bench fro children during bath.
Depending of the product range of the target country Family-model might have wall through parts
for filter preinstalled. This makes filter installation easier since no drilling is required. You just need
to remove the cover from outside of the tub and to connect separately sold connectors and hoses
24/72
05.01.2018
