Charging Cable
DC
The DC receptacle may be used for charging 12 volt automotive-type batteries
only, the zero load voltage is 15V-30V.
1.Connect the charging cables to the DC receptacle of the generator and then to
the battery terminals.
DC output will vary according to the position of the smart throttle switch.
To prevent the possibility of creating a spark near the battery, connect charging
cable first to the generator, then to the battery. Disconnect cable first at the
battery.
Before connecting charging cables to a battery that is installed in a vehicle,
disconnect the vehicles grounded battery cable. Reconnect the vehicle's
grounded battery cable after the charging cables are removed. This procedure
will prevent the possibility of a short circuit and sparks if you make accidental
contact between a battery terminal and the vehicle's frame or body.
Do not attempt to start an automobile engine with the generator still connected
to the battery. The generator may be damaged.
Connect the positive battery terminal to the positive charging cord. Do not
reverse the charging cables, or serious damage to the generator and/or battery
may occur.
4.Switch on the equipment to be used.
In case of overload operation or when trouble occurs for the equipment being used,
the output indicator light(green) will go out, the overload indicator light(red) will light
continuously, and no power will be put out. At this time, the engine will not stop, so
that the engine must be stopped by setting the respective engine switch to STOP.
When equipment requiring a large starting power, like a motor etc., is used,
the overload indicator light(red) and the output indicator light(green)may light
together for a short time (about 4 sec),but this is no abnormality. After start of
the equipment, the overload indicator light (red) will go out and the output
indicator light(green) will stay lit.
CAUTION
WARNING
CAUTION
WARNING
The battery gives off explosive gases; keep sparks, flames and cigarettes away.
Provide adequate venti-lation when charging.
The battery contains sulfuric acid (electrolyte). Contach with skin or eyes may
cause severe burn. Wear protective clothing and a face shield.
-If electrolyte gets on your skin, flush with water.
-If electrolyte gets in your eyes, flush with water for at least 15 minutes and call a
physician.
Electrolyte is poisonous.
-If swallowed, drink large quantites of water or milk and follow with milk of
magnecia or vegetable oil and call a physician.
KEEP OUT OF REACH OF CHILDREN.
The DC receptacle may be used while the AC power is in use.
An overload DC circuit will burnt out the DC circuit fuse. If this happens, change
the fuse with the same kind after unloading.
2.Start the engine.
CAUTION
