Kioti DK 802, Manual

Page: 102 / 121

6-22 DK802/902
ADJUSTING PROCEDURE
1. Loosen the lock nut and turn the ball
joint to adjust the rod length until the
proper toe-in measurement is obtained.
(Same as rod length of left and right
cylinder)
2. Retighten the lock nut.
T30O630A
(1) Lock Nut (2) Ball Joint
CHECKING POWER STEERING LINE
T30O628A
1. Check to see that all hydraulic lines
a n d h o s e c l a m p s a r e t i g h t a n d
undamaged.
2. If damage is found you should replace
the hose or clamp at once.
(1) Power Steering Line
T30O629A
(A) Wheel - to - wheel distance at front
(B) Wheel - to - wheel distance at rear
1. Park tractor on a flat surface.
2. T u r n t h e s t e e r i n g w h e e l s o f r o n t
w h e e l s a r e i n t h e s t r a i g h t a h e a d
position.
3. Lower the implement, lock the park
brake and stop the engine.
4. Measure the distance between tire
beads at front of tire, hub height.
5. Measure the distance between tire
beads at rear of tire, hub height.
6. The front distance should be 2 to 8
mm less than rear distance. If not, ad-
just the tie rod length.
ADJUSTING TOE-IN