1
、
Safety tips
1.1 Proper using maintenance will help to extend the life of film reeler.
1.2 This product needs DC24V input currency. Specialist or electrician is
needed to connect the power. Please don’t connect
AC220V or any
other unspecified power, or there would be damage or fires.
1.3 When the rolling pipe is rolling to high position with the plastics, please
don’t loosen this product with the pipe. Or the rolling pipe will fall down
fast and there would be possibility to hit person or to cause damage
to the product.
1.4 Cut off the electricity when there is lightning or the motor could be
damaged.
1.5 The rolling pipe could be at the same line with the motor shaft. The
curve of the pipe should not be too big, or the motor could be dama-
ged by overload.
1.6 Please check and fasten the bolts connecting the electric film reeler
and its accessories; loose bolts will cause danger.
1.7 If the product didn’t work
，
please don’t uninstall the part inside; you
should stop operating and contact the distributors or the company.
1.8 Please don’t put the product into water and store it in moist environ-
ment; the product could be damaged or cause danger to operators. If
the products have water leaking inside, please stop operating and
send it back to the factory for repair.
1.9 Please don’t toss or throw the products, it should be prevented from
outside force.
1.10 The user should keep the site clean and swipe the leaves or snow on
the plastics to avoid overload damage.
1.11 After the adjust is finished,the user should fasten the bolts or there
might be damage or accidents.
1
10
8
、
Wiring distribution table
Each circuit controls 1 set
24V/300W(GMD300-S)
Installationg Distance
Comtrol Mode
2*4mm
2*6mm
2*10mm
30m
50m
75m
20m
2*2.5mm
2
2
2
2
