LED Tunnel light Installation instruction
Product Dimension
Product outline drawing of type bracket
Product outline drawing L Type bracket
Product Dimension
Unit
Warning: 1. In any case the luminaire shall not be installed on the surface of combustible material.
2. LED module is not replaceable.
4. The broken cable or wire in this luminaire shall only be replaced by a KINGSUN employee or agent or
a similar qualified person.
5. In order to prevent accidents that threaten personal safety, please install and use them in strict
accordance with the instructions.
6. Cut off the power supply before installation to prevent electric shock and need professional electrician
to operate.
7. Ground wire of power supply and controller for all luminaires with 220V input shall be grounded.
Installation instruction
L type bracket installation schematic diagram
the distance between two holes is as below drawing. Thwack
M10mm expansion screws into the holes as shown in the drawing.
Remark: Recommended punch depth >60mm.
Step two: Fix the luminaire onto M10 screws and lock the
L type installation board onto the concrete wall with flat
washer, spring washer and M10 nuts.
Note that the arrow points to the driving direction during installation.
Step three: Connect the power supply cable with remaining power
cable and do insulation and waterproof treatment.
Connection detail A (Please choose the actual power supply cable
color when do connection.)
Detail A
Detail A
Green/Yellow green
Please connect the same
color or same polarity.
Remaining cable
Step one
the distance between two holes is 160mm. Thwack M10mm
expansion screws into the holes as shown in the drawing.
Remark: Recommended punch depth >60mm.
Step Two: Lock the installation board onto the concrete wall
with flat washer, spring washer and M10 nuts. The M10 nut
must be locked with a torque greater than 10.5 N.M.
Note that the arrow points to the driving direction during
installation.
