Kingstone Cliff 250-1, Operating Instructions Manual, Page: 19 / 196

19 19
Lighting instructions
Caution: The lid must be open when lighting the burner!
- Do not stand with your face directly over the gas grill when lighting it.
- Your gas grill will have following method of ignition:
Pilot gas control ignition:
With all gas controls on the gas grill in the “OFF” position, turn the gas cylinder valve to the on position at the
regulator. To create a spark you must push the control knob in (A) and hold in this position for 3 - 5 seconds to allow
gas flow and then turn anticlockwise to ”HIGH” (B). It can spark to the burner lighting tube (C). You will hear a “snap”
from the igniter and you will also see a 3” - 5” orange flame coming from the burner lighting tube at the left side of the
burner (D).
Continue to hold the burner control knob in for two seconds after the “snap”, this will allow gas to flow completely
down the burner tube (E) and insure ignition.
When the burner is alight, adjacent burners will cross light when their controls are turned to “HIGH”.
At “High” setting the burner flame should be approximately 12 - 20 mm long with a minimum of orange flame.
Turn the gas control fully anticlockwise for minimum setting.
Should you have any difficulty lighting your gas grill following the above steps, contact your dealer for advice.
Warning: If the burner still does not light, turn the burner control knob to ”OFF” and wait 5 minutes
to let the gas clear before lighting again.
Side burners (model-specific)
To get the maximum yield with the minimum consumption of gas it is handy to keep the following points in mind:
Once the burner has been alighted, adjust the flame according to your needs, from “Maximum” to “Minimum” position.
Always use matching pots and pans with flat bottoms and a maximum bottom diameter of 24 cm. When the content
of the pan start to boil, turn the knob down to “reduced rate position” (small flame). Always put a lid on the pan.
Infrared burners (model-specific)
If your device has an infrared side burner / rear infrared burner, there is a separate, battery-operated
infrared burner ignition button on the right below the control panel (see next page for replacement battery
instructions) . To ignite the infrared burner, first depress the infrared burner control button and turn it anti-clockwise
to “HIGH”, holding it in this position for 20 seconds. Then press the ignition button again until you hear a click.
After ignition, the ignition button can be released. Press and hold the button for another 20 seconds until the burner
is fully and safely ignited. If your gas grill has internal infrared burners, use them only with opened lid.
Otherwise it can lead to discoloration on side tables and lid.
GB-BAHAG KINGSTONE SERIE CLIFF BDA RZ 2020.qxp 26.08.20 13:59 Seite 19