FCC Compliance and
Advisory Statement
This device complies with Part 15 of the FCC
rules. Operation is subject to the following two
conditions:(1) this device may not cause
harmful interference, and (2) this device must
accept
any interference received, including
interference that may cause undesired
operation.
This equipment has been tested and found to
comply with the limits for a Class B digital
device,
according to Part 15 of the FCC rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates,
uses and can radiate radio frequency energy
and if not installed and used in accordance
with
the instructions, may cause harmful
interference to radio communications.
However, there is
no guarantee that interference will not occur in
a particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning
the equipment off and on, the user is
encouraged to try correct the interference by
one or more
of the following measures:
1.Reorient the receiving antenna.
2.Increase the separation between the
equipment and receiver.
3.Connect the equipment into and outlet on a
circuit different from that to which the receiver
is
connected.
4.Consult the dealer or an experienced
radio/TV technician for help.
Any special accessories needed for
compliance must be specified in the instruction
manual.
Warning:
A shielded-type power cord is
required in order to meet FCC emission limits
and
also to prevent interference to the nearby radio
and television reception. It is essential that
only the supplied power cord be used. Use
only shielded cables to connect I/O devices to
this
equipment.
CAUSION:
Any changes or modifications not
expressly approved by the party responsible
for
compliance could void your authority to
operate the equipment.
Summary of Contents for MLWG3
Page 3: ......
