FDV451 / MQFDV453
-F450F Door Front Kit-
Kit contains:
[1] Door Face with safety screen, [2] DT Screws, [1] Vent Lid.
⚠
WARNING:
Wait until unit is COMPLETELY cool before touching glass or attempting to install or remove Front Face.
1.
Remove the [2] screws from the top mount bracket on
each side of the appliance.
2.
Insert Door Face under appliance top and engage lower
hooks into slots on face of appliance (See next).
3.
Once lower hooks are engaged, insert and tighten [1] DT Screw into mounts on upper sides of Door Face. Replace
the [2] screws from the top mount bracket on each side of the appliance.
IMPORTANT NOTES:
Cotton gloves must be worn to protect the finish during installation and handling.
All fingerprints must be cleaned off with a soft cloth prior to burning the unit or they will be permanent.
Stainless steel may discolor during normal operation. This is normal and should not be considered a defect.
Be sure to remove plastic protective film from stainless steel and clean residue with a damp cloth.
SAFETY BARRIER SCREEN
MOUNT HOOK
MOUNT HOLE
17
Summary of Contents for FDV451LP
