STEP-IV:
Once you are certain that the
LEGS line up with the apron
under
the
TABLE
TOP
ASSEMBLY, Insert all dowels as
shown in the photographs. Use
the wood block provided in between the hammer head and dowel head for the last few blows
to avoid marring the wood.
STEP-V
Fit the BASE ASSEMBLY onto the TABLE TOP
ASSEMBLY and matching the numbers / letters
stamped on the legs to the numbers / letters shown on
the TABLE TOP ASSEMBLY dowel as shown. Use
the wood block provided in between the hammer head
and dowel head for the last few blows to avoid
marring the wood.
STEP-VI
Fit the LEG SUPPORT BRACKETS to the LEGS and APRON as shown
and secure with a proper hand held screw driver. Use of power tools
could easily strip the wood. IMPORTANT: Two people are required to
upright this table, DO NOT ROLL TABLE OVER, legs are NOT
designed to support the weight at that angle. To upright, lift table from
one side without letting weight rest on legs. Then lift off the ground,
rotate to upright position and set table evenly on the ground.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY BATE FURNITURE, PLEASE CONTACT KINGSLEY BATE CUSTOMER
SERVICE AT 703-361-7000. WE THANK YOU FOR CHOOSING OUR FURNITURE.
* KINGSLEY BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone. 703-361-7000, Fax. 703-361-7001
