Is
s
u
e
N
o
:
7
0
4
2
7
8
WEST ROAD . HARLOW
ESSEX . CM
20 2
BG . UK
i n f o @ g r e e n b r o o k . c o . u k
w w w . g r e e n b r o o k . c o . u k
4
.
Position sensor onto back plate and secure using the screw removed in step
1
.
1
.
Turn ‘Time’ control fully anti-clockwise and
‘Lux’ control fully clock wise refer to Dia:
4.
2.
Re-connect mains supply, allow
30
seconds
for the sensor to warm-up, and then
perform a walk-by in front of the sensor;
lamp should turn on and stay on for
approximately
10
seconds, and will go off if
no further movement is detected.
TESTING
ADJUSTING THE ‘LUX’ CONTROL
1
.
Turning Lux control fully clock wise, the sensor will operate in both daylight and darkness.
2
.
Turning Lux control fully anti-clockwise, the sensor will operate in darkness only.
3
.
Set control to operate at your required daylight level.
ADJUSTING THE ‘TIME ON’ CONTROL
1
.
Turning the time control fully anti-clock wise will set the on duration to
10
s/-
3
seconds.
2
.
Turning the time control fully clock wise will set the on duration to
15
m/-
2
minutes.
TROUBLE SHOOTING
Light not coming on
•
Check that lamp is good.
•
Check there is nothing obscuring the PIR sensor.
Intermittent operation
•
Check there are no curtains that can move in the wind.
•
Check there are no heating vents nearby.
PLEASE KEEP THESE INSTRUCTIONS
SAFE FOR FUTURE REFERENCE
TECHNICAL INFORMATION
Rated Voltage:
230
V
～
50
Hz
IP Rating:
IP
65
Ambient Light
:
<3-2,000 LUX (
Adj
)
Time Delay:
Min
10
sec ±
3
sec
Max
15
min ±
2
min
Rated Load:
Max
1200
W
Max
300
W
Detection Range:
180
°
Detection Distance:
12M
max (<
24
°C)
Working Temp:
-
20
° - +
40
°C
Working Humidity:
<
93
%RH
Power Consumption:
0.5
W approx
Installation Height:
1.8 - 2.5
M
Detection Moving Speed:
0.6 - 1.5
m/s
Dia:
4
Dia:
3
3
.
Secure the sensor back plate to the wall using
two wood screws (ensure there is no
wiring/gas/water services directly behind the
screws) Dia:
3
.
/LED
OD103 Ins .qxp_GU10 20/11/2015 13:16 Page 2
