7
Getting Started
Starting Your Skid Sprayer for the First Time (continued)
14.
Check all plumbing connections to ensure tightness.
15.
Ensure all valves and regulators are set to the desired setting and working properly.
16.
Ensure all hoses are positioned properly and undamaged.
17.
Follow the next steps on starting the engine.
18.
Set the engine ON/OFF switch to the ON position.
19.
For a cold start, set the choke to FULL.
20.
Make sure the throttle is at SLOW.
21.
Turn the gas switch to the ON position.
22.
Pull start the engine.
23.
Release the choke.
24.
Raise the throttle to FULL.
25.
The regulator has four settings. Set the base pressure with the adjustment nut.
a. When the regulator is engaged in the number one position (located farthest from
the brass nut), the pressure is roughly 100 psi;
b. In the number two position, the pressure is approximately 250 psi;
c. In the number three position, the pressure is roughly 450 psi;
d. In the number four position, the pressure is about 550 psi;
e. To fine-tune the pressure rating, use the brass nut on top of the spring.
26.
The left lever turns ON pressure to the spray gun.
27.
The right lever turns ON the agitator. You will notice a drop in pressure when the
agitator is engaged. The agitator mixes the tank and helps to evenly dispense
chemical.
28.
Adjust the spray gun to the desired setting and you are ready to spray.
Shutting Down Your Skid Sprayer
1.
Shut sprayer down using the outlined steps.
2.
Release the pressure.
3.
Turn the engine ON/OFF switch to the OFF position.
4.
If pump will not be used for several hours flush your system to prolong the life of the
components.
For a step-by-step video guide, visit the Sprayer Depot YouTube Channel to watch instructional
videos on a variety of topics. Tune in by visiting
http://YouTube.com/SprayerDepot
.
Engaging / Disengaging the Regulator
For regulators found on
roller pumps and 3-
Point Hitches, leaving
regulators engaged will
not hurt the pumps.
Pump Model
Engage
Disengage
Hypro D30
Move lever down
Move lever up
Hypro D252
Turn knob to “C”
Turn knob to “A”
Iota 20
Turn lever clockwise
Turn lever counterclockwise
Kappa 40
Move lever up
Move lever down
Kappa 43
Turn lever clockwise
Turn lever counterclockwise
