INSTALLATION
The head of the amplifier may be mounted
outside on the pole under the antenna or in the
roof. The amplifier requires F type connectors.
The power supply unit (
FIG.1
) is placed at a
television outlet, or at a remote location, a low
voltage then runs up the cable to power the
head remotely, via the output. There are no
controls inside the housing, however there is an
LED that when on, indicates power is present.
Bare back cable with a cable stripper or Stanley
knife (
FIG.2
).
Slide on F connector and crimp or use a twist-on
connector (
FIG.3
).
Note:
Depending on the wall plate installed and
model power supply used, you may need to
use adaptors.
FIG.1
FIG.2
FIG.3
3
PSK06F
INPUT
14
VO
LT
DC