Quick Reference Guide
–
KI-TK800 Series MPO Visual Cable Verifier
Revision 2
Date: 23 Nov 2017
Page
2
of
4
KI 28800 series Light Source operation
•
Only insert MPO
female (no pin) connector into instrument’s
optical adaptor(s). You can use either MM or SM fiber.
•
To turn instrument on press [On/Off].
•
To view firmware version, hold [F4] then press [On/Off].
•
To view all display segments, press and hold[On/Off], [F1] at the
same time until it stops beeping.
•
To defeat auto power-off
,
hold [On/Off] for 3 seconds at turn on
until ‘Perm’ is displayed.
•
Low battery is indicated with a battery symbol.
•
To turn on emitters, press [F1/Source].
•
To turn off emitter, and return to Home menu, press [Home].
•
To turn on back light press [
].
KI 6608 40x magnification microscope operation
•
If needed, replace universal optical adaptor with an
MPO12xn or MPO16xn adaptor.
•
Before inserting any MPO connector, check the scope
MPO adaptor lateral position, and If necessary, use the
MPO adaptor alignment screw to adjust the connector to
the mid-position.
•
Rotate microscope to the position at which the “TOP” label
on adaptor is facing up. Note that image is reversed when
viewed through microscope.
•
Insert connector to be inspected.
•
Press and hold front switch of blue toggle button to use green
oblique illumination. This is very well to show dirt on the end face.
•
While holding eye piece to your eye, adjust focus knob to achieve
a clear image of connector tip.
When image is in focus, the centre
of XY-alignment screw is positioned near the white arrow on the
right of focus knob
.
•
Rotate XY-alignment screw to position image of connector tip at
the centre.
•
With “TOP” label facing up
, determine MPO cable type by
comparing the pattern image of microscope with that shown on
MPO Cable Verification Pattern Guide
which comes with the
instrument.
•
Releasing the front switch of toggle button now will change to
microscope illumination to coaxial mode.
•
To turn off illumination manually, press rear button of blue toggle
button, or it will also automatically turn off later.
•
To disable auto-off timer, power unit with external supply via
USB.
