113
02
To Set Up Connectivity
1.
Make sure that the hob and the hood are switched off.
2. Switch on the hood and press the Timer icon
and Light icon together on the control panel of the
hood. The LED display will flash.
3.
Press any of the control knobs down for approximately ten seconds to connect the hob to the hood and
the thermocouple will click constantly.
After connection is made, the hood will display “A” in its control panel and the hob will show the RF
connectivity icon on the glass to indicate that the hob and hood are paired.
IMPORTANT:
The connectivity operation above must be completed within two
minutes of turning on the power to the hood. If this is not successful, switch off
both the hood and the hob, wait for one minute and attempt the connectivity
again.
03
Using The Connectivity Function
The extraction rate of the hood will vary based upon the total power output selected on the hob, as shown in
the table. Each hob cooking zone has a maximum rated output of 6.
Hob: Gas on glass 4 burner GH60GASLK
Hood: Chimney and Curved Glass models, for example: CLCH60LKSS, GHCH60LKBL, CLCG60LKSS.
Speed Level of the Hood
Combined Power Output of the Hob
Speed 1
The combined output is 4 or less. For example, zone 1 is on 1, and zone 2
is on 2.
Speed 3
The combined output is between 5 and 8. For example, zone 1 is on 2,
zone 2 is on 2 and zone 3 is on 3.
Speed 5
The combined output is between 9 and 16. For example, zone 1 is on 2,
zone 2 is on 3, zone 3 is on 5 and zone 4 is on 4.
Speed P
The combined output is greater than 17. For example, zone 1 is on 5, zone
2 is on 6, zone 3 is on 6 and zone 4 is on6.
5059340445793_MNL_IN_V03.indb 113
5059340445793_MNL_IN_V03.indb 113
07-06-2022 14:49:22
07-06-2022 14:49:22
