What is included:
1 Piece of individual control desk,
2 Pieces of safety keys.
1 Instruction manual.
1 Piece of charger with DC15V 0.5A output power.
Charging the system:
The Battery Status Light will only operate when the unit is switched ON and in Fire mode.
However the system will charge even when switched off.
Battery Status Light
Description
RED (flashing)
Battery Low.
RED (steady)
Battery Charging.
RED / GREEN (flashing)
Battery Almost Full.
GREEN (steady)
Battery Full.
Lead Acid Batteries naturally discharge over time. To keep the battery in good condition it
is recommended the system is charged every 2-3months. Storing the system in extremely
low or high temperatures will shorten the life of the battery.
Basic transmitter operation:
Button Description
CONFIRM
Single Fire Mode:
1-20 Fire individual cues.
SEQ + CONFIRM
Sequence Fire Mode
: Fire the cues in sequence with a set delay
between each cue.
STEP + CONFIRM
Step Fire Mode:
Fire the cues sequentially with each successive
button press. Holding STEP down continuously will cause multiple
cues to fire.
ALL + CONFIRM
All Fire Mode:
Fire all the cues.
RECEIVER
SELECTION
DIAL (1-11, S )
Transmitter Address:
Position 1-11: Select which receiver(s) to control when more than 1
receiver is used.
Position S: To have a sequence firing function roll from 1 receiver to
the next. Each receiver must have an address set up and sequence
time must be same. The receiver must be programmed with the
transmitter RECEIVER SELECTION DIAL in the S position.
CONFIRM
This is a safety feature to prevent accidental use.
POWER SWITCH
Transmitter power ON/OFF.
SAFETY KEY
SWITCH
The SAFETY KEY must be switched to ON for the transmitter
to send a signal.
STOP / CONT
Send a signal to stop or continue a sequence.
LED ON/ OFF
Switch the Cue Display ON / OFF to save the power.
UP / DOWM
Increase / decrease the cue number.
TIME ON / OFF
Switch the Total time / Interval time Display ON / OFF.
RADIO CONTROL
Switch to the wireless control mode.
LINE CONTROL
Switch to the wired control mode.
Deprogramming module and re-programming
Warning: 1. You must deprogram the receiver module prior to trying to re-program it.
2. Never program the receiver when another transmitter is transmitting. This
may cause the receiver to be programmed with wrong transmitter.
To clear the receiver of previously stored transmitters:
1.
Put receiver function selection switch to FIRE position.
2.
Hold the receiver Program button until the program light goes out.
To program the receiver with a new transmitter (Wireless type ):
1.
Put receiver function selection switch to FIRE position,
2.
Switch transmitter power ON, turn transmitter safety key to ON and put the control
type switch to RADIO position.
3.
Set transmitter receiver selection dial to desired position.
4.
Press and hold CONFIRM and SEQ, ALL or STEP so that the transmitter is
continuously transmitting. At the same time press and release the receiver
PROGRAM button immediately. The receiver program light blinks twice to indicate
the receiver has been programmed.
5.
Release CONFIRM and SEQ, ALL or SEP buttons so that the transmitter is not
transmitting.
To program the receiver with a new transmitter (Wired type ):
Page 4 of 7
Page 3 of 7
