CONNECTION OF THE WATER SUPPLY TO THE PRESSURE WASHER
Connect the water supply to the water inlet on the front of the pressure inlet.
Turn on water supply.
FIG. 31
LOCKING AND UNLOCKING THE TRIGGER ON THE GUN LANCE
The trigger lock is meant to prevent the unintentional discharge of the spray gun.
How to lock the trigger:
Pull the handle forward
Slide the lock latch down to the arrow marked on the gun handle
Release the trigger
How to unlock the trigger:
Pull trigger forward
Slide the locking latch so that the latch is flush next to the trigger
Release trigger
BLEEDING THE GUN
It is very important to bleed the gun before using the pressure washer. Squeeze the
trigger to allow any air that is trapped inside of the unit and hose to escape. Continue to
squeeze trigger until a steady stream of water comes from the nozzle. This process may
take up to 2 minutes.
ELECTRICAL CONNECTION OF THE APPLIANCE
The main voltage and the working voltage must correspond (see identification
plate on machine).
Insert the GFI power plug into a power outlet (see GROUNDING INSTRUCTION,
page 3).
FIG. 32
16
