Setting the Timer
•
Ensure the slide switch on the timer is at the mid position next to the clock symbol.
•
Rotate the outer ring of the timer in a clockwise direction until the current time is lined up with
the arrow pointer, i.e. if the time the timer is being set is 8pm, rotate the outer ring until the
number 20 is in line with the arrow pointer.
•
Set the time the heater is required to run by pulling the segments around the outer ring forward
appropriate to the running period(s) required.
•
When set, the heater will operate each day during the times programmed.
Note
, the heater
must always be plugged into a power socket, the element switches must be in the on position
and the thermostat must be suitably set to ensure the heater will come on.
If the heater is required to run continuously the slide switch on the timer should be set to the “I”
position. If it is subsequently required to revert back to timer operation, the slide switch on the
timer should be set to the central (clock) position.
Note:
When using in timer mode, due
consideration should be given to the fact that the heater may come on whilst unattended.
Helpful Tips
Always un-plug the heater from the wall socket and allow it to cool down before cleaning.
Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.
Do not use any detergents or abrasives and do not allow any water to enter the heater.
Storing the Appliance
When the heater is not used for long periods of time it should be protected from dust and stored in
a clean dry place. For any further advice, contact the helpline.
For your records and guarantee purposes, attach your sales receipt to this manual
(Staple sales receipt here)
.
Environment
