Page 1
OPERATION
The wall mount Power Injector is a convenient way to
switch between your cable feed and over-the-air signals
from your KING Jack antenna.
To use the Power Injector, simply turn the unit on with the
ON/OFF button. When on (button depressed), the power
light will turn green indi12 volts to the antenna,
and the over-the-air signal from your KING Jack antenna
will be fed to the two TV outputs.
When off, the cable TV signal will be fed to the two TV
outputs if wired for cable TV input.
POSITIONING THE ANTENNA
1. Turn on Power Injector (power is now supplied to the KING Jack antenna).
2. Turn on KING SureLock Signal Meter with switch on side of rotational knob enclosure.
3. Rotate attenuator dial fully clockwise.
4. Depress button on rotational knob and rotate antenna
until maximum number of LED lights illuminate on signal meter.
5. Rotate attenuator dial counter clockwise until last illuminated LED light flickers.
6. Rotate antenna to illuminate last flickering LED light.
7. Repeat steps 5 and 6 to pinpoint signal reception.
8. Follow instructions for TV or converter box to scan for available channels.
SPECIFICATIONS
Dimensions:
11.25” H x 16” W x 12.5” L
Weight:
2.3 lbs.
Frequency Bands:
VHF (47-230 Mhz) - 20 db gain
UHF (470-860 Mhz) - 25 db gain
Signal Meter
Frequency Response:
40-862 Mhz (Ch 2-69)
Powered Amplifier:
+12 Volt / 100 mA working
Power Supply:
Power Injector (included)
• KING #PB1000 - power supply, white
Enclosure/Mount:
ASA-Automotive grade
NOTE:
In step 4, LED lights will illuminate from left (next to power) to right.
All LED lights may not illuminate depending on signal strength.
NOTE:
Arrow on knob indicates which
direction antenna is pointing.
NOTE:
Before beginning the installation on page 2, see page 5 for information about the MB8000 Mounting Plate.
You must install the included wall mount Power Injector to operate the KING Jack antenna (page 5).
Thank you for choosing a KING Antenna!
