ADJUSTMENTS AND OPERATION
RAISING OR LOWERING WORk TABLE
1. Loosen table lock handle (A) Fig.9.
2. Turn the table height adjustment handle (B) until the table is at the
desired height.
3. Retighten table lock handle (A).
ADJUSTING ANGLE OF WORk TABLE
1. Loosen table lock handle (A) Fig.9.
2. Swing the table (C) to the desired position.
3. Retighten table lock handle (A).
Note: When working with taller workpieces, swing the table 180° out of
the way and use the base as a table.
USING THE DEPTH STOP
The depth stop mechanism Fig.10 allows repetitive drilling to an equal
depth, to adjust the depth stop mechanism:
1. Lower the downfeed handles until your cutting tool reaches the desired
drilling depth.
2. At the same time, position the bottom hex. nut (A) Fig.10 against the
head casting (B).
3. Release the downfeed handles and check your adjustment.
4. If properly set, tighten hex. nut (C) against hex. nut (A) to secure the
adjustment. Depth stop mechanism is now set and you can now do
repetitive drilling at equal depth.
CHANGING SPEED
This drill press has a variable spindle speed range of 400 to 5000 RPM,
the speed setting is conveniently displayed on the digital readout on the
head of the drill press. To set the spindle speed:
WARNING!
Always adjust the spindle speed while the drill press is
running to avoid damaging the speed adjustment mechanism.
1. Turn the drill press on.
2. The spindle speed is controled by the speed adjusting handwheel (A)
Fig.11 located on the left side of the drill press head.
3. Turn the handwheel clockwise to increase the spindle speed.
4. Turn the handwheel counterclockwise to decrease the spindle speed.
5. Refer to the digital readout (B) on the front of the drill press head to
set the desired speed.
Refer to the reference chart (Fig.12) for recommended speed selection,
based on the drill bit size and workpiece material.
FIGURE 9
FIGURE 10
FIGURE 11