Spray
1.
The spray can be used in any position, either in dry or steam ironing, as long as the
water tank is filled with water.
2.
Press the spray button for this function
NOTE :
This button has to be pressed repetitively to start this function for the first time.
Shot of steam
Shot of steam give extra steam for removing persistent wrinkles.
1.
Place the temperature selector at the “max”position and wait until the pilot light goes out.
2.
Wait for a few seconds for the steam to penetrate the fibre before pressing again.
NOTE:
For the best steam quality, do not use more than three successive bursts each
time. Several pumping actions are needed to start this function. Excessive use of this
feature will cause the iron to cool, ensure that the pilot light is out, before operating the
shot of steam control.
Cleaning
1.
Disconnect the appliance from the mains, before cleaning.
2.
Do not use solvents or abrasive products to clean the iron, clean with a damp cloth.
Defects and repairs:
Do not attempt to replace a defective mains lead .The appliance
has to be returned to an authorized service centre for repair. Faults-reasons and
solutions.
Iron emits an odor or smoke:
Iron gives off an odor when turned on for the first time.
Oils used during manufacture need to be burnt off allow ten minutes for odor to
disappear. Iron does not heat. The iron should be plugged into a 230 Volt, AC electrical
outlet only. The temperature dial must be set at the desired temperature.
Iron does not steam:
The water tank many be empty. Turn the steam valve to “0” and
add water .Allow the iron to heat, and then set the steam dial to the steam setting.
Burst of steam feature does not work:
The water tank must be at least 1/4 full.Tem-
perature must be set to steam position. Iron should be in the horizontal position. Prime
pump briefly. Allow a short pause between shots. Be sure to fully depress the burst of
steam button. Spry mist feature does not work. The water tank must be at least 1/4 full.
Fill the iron as described in the section “how to fill the water tank”.
Iron is leaking:
The variable steam dial must be set on” “,until the iron is hot . The
temperature setting is too low to produce steam. Shot of steam used too much, allow
iron to re-heat.
