Http://www.GSMalarmsystem.com
King Pigeon Hi-Tech. Co., Ltd. Page
１２
of 17 Ver 1.1 File No.: 36220010
31charaters
80##
Inquire the pre-set SMS
81#*#
Set wired sensor 1’s alert SMS
content.
* means content, the
content should not
more than 20
characters.
82#*#
Set wired sensor 2’s alert SMS
content.
83#*#
Set wired sensor 3’s alert SMS
content.
84#*#
Set IR Camera’s alert SMS content.
85#*#
Set Wireless Sensors alert SMS
content.
90##
Inquire the status of the output relays
91#1#*
Switch on Output reply 1
91#0#
Switch off output reply 1
92#1#*
Switch on output reply 2
92#0#
Switch off output reply 2
Note:
1. All of the above mentioned commands, should add the password as its
prefix, for example: Switch off output relay 2, should edit a sms content:
123456#92#0#, the 123456 is the password, end with #,then following
the commands.
2. The wired sensors inputs are NO, means when triggered, the relay in the
wired sensor will close and triggered the Control Unit;
3. Reset Button: Press the reset button then switch on the Control Unit, last
3 seconds the realease it. The system will recovery to the factory default
settings, including removed the remote control and wireless sensors;
4. Add wireless sensors and remote controls: When the Signal Led
continues green color, then press the Reset button for 1 second, the
Signal Led will turn to Red color, trigger the wireless sensor or press any
key of the remote control is ok. The first added wireless sensor will be set
as Zone 1, the second added wireless sensor will be set as Zone 2, -----,
the last added wireless sensor will be set as Zone 8. Please repeat the
same operation to add the second,third,----eighth wireless sensor.
