KING-METER TECHNOLOGY CO., LTD
No.15, Chenchang Road, Beichen Dist.Tianjin,300134,CN
Fax
：
+0086 022 8478 0358 Tel: +0086 022 8478
7
5.2.2 Swipe RFID Card
When the display is turned on normally, there will be a prompt swiping interface. When the prompt
swiping interface is turned on, the level indication will turn on from high to low, and all lights will go out.
It will display in a loop until the card is swiped. At this time, swiping the secondary card directly enters the
main interface and starts to work; swiping the main card power indicator flashes and then shuts down,
and powers on again to enter the card matching interface.
5.3 6km/h Walk assist function
Hold the MODE button after 2 seconds, the e-bike enters the state of walk assist. The e-bike is riding
at a constant speed of 6 km/h, and the level position indicator is not displayed.
The power-assisted push function can only be used when the user pushes the e-bike, please do not
use it when riding.
5.4 Headlight on and off
Pressing the LIGHT button, notify the controller to turn on the front light. Pressing the LIGHT button
again to turn off the headlights.
5.5 PAS level setting
Short press the MODE button to switch the power-assisted level of the e-bike and change the output
power of the motor. The default output power range of the meter is 0-3 level, level 0 is no output
level, level 1 is the lowest power, and level 3 is the highest power. The default level when the display
turned on is level 1.
5.6 Battery Indication
When the battery voltage is high, the four LED power indicators are all on. When the battery is under
voltage, the last power indicator flashes for a long time, indicating that the battery is seriously under
voltage and needs to be charged immediately.
