19
LIGHTING AND OPERATING INSTRUCTIONS
THE COOKER MUST NOT BE LIT UNTIL THE PRECEDING
PLACEMENT INSTRUCTIONS HAVE BEEN COMPLETELY FOLLOWED.
Pot must be installed onto cooker frame and filled with water before lighting appliance.
The lid support rod must be in straight or angled position before lighting appliance.
1.
Make certain that the regulator control is turned to OFF by turning it counterclockwise until it reaches the stop.
2.
Open cylinder control valve by turning it counterclockwise as per the diagram
(Figure 2)
.
3.
Locate the two lighting access holes that are located on the front plate of the appliance (see
Figure 1
.) The cooker
must only be lit through these lighting holes. N
EVER ATTEMPT TO LIGHT IN ANOTHER LOCATION OTHER THAN
THE LIGHTING HOLES.
If using a match to light the appliance, the lighting rod which is attached to the cooker must be used. Attach the
match to the end of the lighting rod. Light the match, or alternatively a multipurpose lighter, and turn the regulator
control toward the ON position. Insert the end of the multipurpose lighter or lighting rod with lit match into
EACH
lighting access hole until ignition occurs (see
Figure 3 or Figure 4
.)
Make sure each jet pipe is properly lit.
Turning
the regulator control clockwise increases the gas pressure to the burner and hence the flame size
(Figure 2)
.
When lighting the cooker, if ignition does not occur in 3 to 5 seconds, turn the regulator and cylinder valve off. Wait
5 minutes for gas to disperse. Repeat procedure. Refer to
Figure 5
for proper flame emission.
4.
Always monitor the flames throughout the cooking process. If at any point in the cooking process the flames are
accidentally extinguished, immediately turn the regulator and cylinder valve OFF. Wait 5 minutes for gas to disperse
and relight the cooker according to the lighting instructions. (#1 - #4) in this section.
NEVER PUT HANDS OR FACE DIRECTLY OVER BURNER WHILE LIGHTING
OR WHILE THE APPLIANCE IS LIT.
FIGURE 1
FIGURE 3
Lighting Holes
Jet Pipes
FIGURE 4
FIGURE 5
Multipurpose
Lighter
Lighting
Rod
and Match
Jet Pipe
Note - The above picture
shows an example of a
properly lit jet pipe. Your
model has two jet pipes.
Both jet pipes must be
lit.
(
.61m
)
24
“
20LB. LP
GAS
CYLINDER
Jet Pipe
Jet Pipe
Turn Cylinder Handle
toward ON
(Counterclockwise)
Next
Turn Regulator Control
toward ON
(Clockwise)
ADJUSTABLE REGULATOR
FIGURE 2
20LB. LP
GAS
CYLINDER
* Models may
vary from picture
.