ASSEMbLY
dISASSEMbLINg & INSTALLINg NEW CANISTER FILTER
unbolting used canister filter
1. From inside the isolation panel, remove the 10 flange head hex. bolts (B) Fig.1
to detach canister filter (A) from the Cyclone Dust Collector housing.
Installing canister filter to Cyclone dust Collector housing
1. Remove the canister filter shaft (A & C) Fig.2 assembly from the old canister
filter and reinstall it on the new canister filter. Tighten cap screws (B). Make
sure one cap screw is tightened against the flat of the canister filter shaft.
Tighten cap screw (D). Make sure cap screw is tightened against the flat of the
auto-clean shaft.
2. The KC-8500C Cyclone Dust Collector comes with an auto-clean motor
(shown uninstalled in Fig.3) which automatically turns the canister filter
paddles to dislodge dust. Before attempting to install the canister filter, it is
extremely important that the auto-clean shaft (C) Fig.2 gets positioned in
between the fork assembly (A) Fig.3. With the help of another person, position
the canister filter (A) Fig.1 under the main impeller housing and the isolation
panel, line up the auto-clean shaft and the fork assembly and raise the
canister filter up against the main impellor housing. Secure canister filter using
10 flange head hex. bolts (B) Fig.1.
3. Secure the canister filter dust bag to the bottom of the canister filter using the
retaining strap supplied with the Cyclone Dust Collector.
PARTS dIAgRAM & PARTS LISTS
Refer to the Parts section of the King Canada web site for the most updated parts
diagram and parts list.
FIguRE 1
FIguRE 2
FIguRE 3