WARNING:
YOUR DOUBLE CUT SAW MUST BE CONNECTED TO A 120V, 15-AMP
CIRCUIT. FAILURE TO CONNECT IN THIS WAY CAN RESULT IN INJURY FROM
SHOCK OR FIRE.
DOUBLE INSULATION TOOLS.
Double Insulation is a design concept used in electric
power tools which eliminates the need for the three wire grounded power cord and
grounded power supply system. It is a recognized and approved system by Underwriter’s
Laboratories, CSA and Federal OSHA authorities.
IMPORTANT:
Servicing of a tool with double insulation requires care and knowledge of the
system and should be performed only by a qualified service technician. WHEN
SERVICING, USE ONLY
IDENTICAL
REPLACEMENT
PARTS OR THOSE
RECOMMENDED BY THE MANUFACTURER.
POLARIZED PLUGS
: Your tool is equipped with a polarized plug (one blade is wider than
the other), this plug will fit in a polarized outlet only one way. If the plug does not fit fully in
the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the
proper outlet. To reduce the risk of electric shock, do not change the plug in any way.
EXTENSION CORDS.
The use of any extension cord will cause some loss of power. Use
the following chart to determine the minimum wire gauge (A.W.G-American Wire Gauge)
extension cord. Only use polarized extension cords (one prong wider than the other) which
have 2-prong type plugs and 2-hole receptacles which accept the tool’s plug.
For circuits that are further away from the electrical circuit box, the wire gauge must be
increased proportionately in order to deliver ample voltage. Refer to chart for wire length
and size.
ELECTRICAL INFORMATION
WARNING!:
If any parts are missing, do
not operate until missing parts are
replaced. Failure to do so could result in
serious personal injury.
WARNING!:
Do not use this product as a
component of others products. Also, do not
use attachments or accessories not recom-
mended for use with this product. Any such
use could result in possible serious injury.
Tool’s
Amperage
Rating
3-6
6-8
8-10
10-12
12-16
Cord Size in A.W.G.
Cord Length in Feet
25
50
100 150
18
16
16
14
18
16
14
12
18
16
14
12
18
16
14
12
14
12
-
-
Technical Specifications
Blade size ..........................................................................................................6-3/8”
Depth of cut ......................................................................................................1-3/8”
Voltage................................................................................................................120V
Amperage ............................................................................................................10A
R.P.M. ................................................................................................................4,200
Cycle/Phase ........................................................................................60Hz, 1 phase
GETTING TO KNOW YOUR
DOUBLE CUT SAW
1. On/Off switch
2. Carbon brush cover (1 of 2)
3. Motor housing
4. Control handle
5. Lubrication system
6. Lubrication system feed wheel
7. Lower blade guard
8. Arbor flange
9. Arbor flange hex. bolt
10. Lower blade guard lever
11. Arbor adjustment key
12. Lubricating wax sticks (10)
13. Spindle lock button
14. Switch lock button
