AsseMbly
6. Secure the top section of the canister filter (A) Fig.7 to the mounting
bracket (B) on the back of the main impellor housing (C) using flange
head bolts and nuts.
7. Install the canister filter support bar (D) Fig.7 to the bottom section of the
canister filter (A) and the base (E) using flange head bolts.
8. Stick foam (F) Fig.7 around the bottom lip of the canister filter (A). Then
install and secure the canister filter plastic bag (G) to the bottom lip of
the canister filter (A) using the bag clamp (H).
9. Stick foam (I) Fig.7 around the lip on the inlet of the canister filter (A) and
around the lip of the main impellor housing (C). Then install and secure
the small flex hose (J) to the inlet of the canister filter (A) and the outlet
of the main impellor housing (C) using the small hose clamps (K).
10. Stick foam (A) Fig.8 around the lip on the cone (B) and around the lip
of the drum lid (C). Then install and secure the large flex hose (D) to the
cone and drum lid using the large hose clamps (E).
Note: The foams (F & I) Fig.7 and (A) Fig.8 serve to restrict air flow at
these joints, install the clamps over the foam for best performance.
11. Install the handle (F) Fig.8 to the canister filter (G) by tightening the set
screw and hex. nut.
12. Install the hose inlet (H) Fig.8 to the main inlet using a pan head screw.
13. Install the drum lid levers (A) Fig.9 to both sides of the cone brackets
(B) using pan head screws. Then secure the drum lid levers to the drum
lid brackets (C) using the flat nuts and and special nuts (D). These
levers are meant to raise the drum lid so the drum can pulled out and
emptied.
FIGure 7
FIGure 8
FIGure 9
