ASSEMBLY
DISASSEMBLING MOTOR BRACKET
For shipping purposes, a motor bracket (A) Fig.4 is bolted to the cabinet and
attached to the motor mount. This motor bracket must be removed before
assembling, adjusting or operating this cabinet saw. You should keep this motor
bracket in case you plan on shipping your cabinet saw.
INSTALLING MOTOR ACCESS DOOR
To prevent air born saw dust, the motor access door (A) Fig.5 should be
installed to the cabinet. Slide the motor access door hinge pins (B) into the
hinge supports in the cabinet. Swing and close the access door and lock it into
place using the supplied lock knob (C).
ASSEMBLING EXTENSION WINGS
Important Note: There is a right and a left side extension wing, each extension
wing has a beveled edge, this beveled edge must be positioned towards the
front of the saw.
Fasten each extension wing to the table using 3 cap screws, spring washers
and washer. To allow adjustment, do not fully tighten the cap screws. Align the
beveled edge of each extension wing with the beveled edge of the table.
Using a straight edge, level the extension wings to the table surface as shown
in Fig.6. Verify the adjustments, once the extension table is flush with the front
and top of the table, tighten the cap screws.
ASSEMBLING HANDWHEELS
Position a key into the keyway of the shaft, align the keyway of the handwheel
(A) Fig.7 and slide it onto the shaft. Tighten the set screw on the handwheel hub
to secure it in place. Insert the center lock knob (B) into the center hole in the
shaft and tighten in a clockwise direction. Then thread the handwheel handle
(C) into the handwheel. Repeat for the second handwheel.
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7
