AsseMbly
1. Install the four casters (A) Fig.5 to the under side of the base (B). Se-
cure the four casters to the base using 4 washers and acorn hex. nuts
(C). Tighten using the supplied wrench.
2. Place base with casters (A) Fig.6 on the ground and install the motor
support (B) to the base using 4 hex. bolts (C). Tighten using the sup-
plied wrench.
3. Install the motor and ventilation housing assembly (A) Fig.7 to the
motor support (B) using 4 flange head hex. bolts (C).
4. Install two of three support brackets (A) Fig.8 to the base (B) using 2
flange head hex. bolts (C) for each of the support brackets. Install third
support bracket (A) to the base using a motor support flange head hex.
bolt (D) as shown. Hand tighten only at this point.
5. Install filtration housing (E) Fig.8 to the three support brackets (A) using
2 flange head hex. bolts (F) on each support. Make sure the hose open-
ing (G) faces the ventilation housing opening. Tighten all flange head
hex. bolts at this time using the supplied wrench.
6. Install handle (H) Fig.8 to the filtration housing (E) using two flange
head hex. bolts (H). Tighten using the supplied wrench.
FIGure 5
FIGure 6
FIGure 7
FIGure 8