general saFety instructions
For power tools
1. know your tool
Read and understand the owners manual and labels affixed to
the tool. Learn its application and limitations as well as its
specific potential hazards.
2. ground tHe tool.
This tool is equipped with an approved 3-conductor cord and a
3-prong grounding type plug to fit the proper grounding type re-
ceptacle. The green conductor in the cord is the grounding wire.
never
connect the green wire to a live terminal.
3. keep guards in place.
Keep in good working order, properly adjusted and aligned.
4. remove adJusting keys and wrencHes.
Form habit of checking to see that keys and adjusting
wrenches are removed from tool before turning it on.
5. keep work area clean.
Cluttered areas and benches invite accidents. Make sure the
floor is clean and not slippery due to wax and sawdust build-
up.
6. avoid dangerous environment.
Don’t use power tools in damp or wet locations or expose them
to rain. Keep work area well lit and provide adequate surround-
ing work space.
7. keep cHildren away.
All visitors should be kept a safe distance from work area.
8. make worksHop cHild-prooF.
Use padlocks, master switches or remove starter keys.
9. use proper speed.
A tool will do a better and safer job when operated at the
proper speed.
10. use rigHt tool.
Don’t force the tool or the attachment to do a job for which it
was not designed.
11. wear proper apparel.
Do not wear loose clothing, gloves, neckties or jewelry (rings,
watch) because they could get caught in moving parts. Non-slip
footwear is recommended. Wear protective hair covering to
contain long hair. Roll up long sleeves above the elbows.
12. always wear saFety glasses.
Always wear safety glasses (ANSI Z87.1). Everyday eyeglasses
only have impact resistant lenses, they are
not
safety glasses.
Also use a face or dust mask if cutting operation is dusty.
13. don’t overreacH.
Keep proper footing and balance at all times.
14. maintain tool witH care.
Keep tools sharp and clean for best and safest performance.
Follow instructions for lubricating and changing accessories.
15. disconnect tools.
Before servicing, when changing accessories or attachments.
16. avoid accidental starting.
Make sure the switch is in the ‘’OFF’’ position before plugging
in.
17. use recommended accessories.
Consult the manual for recommended accessories. Follow the
instructions that accompany the accessories. The use of im-
proper accessories may cause hazards.
18. never stand on tool.
Serious injury could occur if the tool tips over. Do not store ma-
terials such that it is necessary to stand on the tool to reach
them.
19. cHeck damaged parts.
Before further use of the tool, a guard or other parts that are
damaged should be carefully checked to ensure that they will
operate properly and perform their intended function. Check for
alignment of moving parts, breakage of parts, mounting, and any
other conditions that may affect its operation. A guard or other
parts that are damaged should be properly repaired or replaced.
20. never leave macHine running
unattended.
Turn power ‘’OFF’’. Don’t leave any tool running until it comes
to a complete stop.
