CLEANING, ASSEMBLY
& PARTS DIAGRAM/PARTS LIST
CLEANING
This Cast-Iron Table comes with a protective coating to prevent the table
from rusting during transport. Carefully remove table from the box. Clean
table using a rag soaked in kerosene or paint thinner, discard rag once
cleaning is done.
To further prevent rust, it is recommended to apply a light coating of paste
wax or rust inhibitor.
ASSEMbLY
MOUNTING LEVELING SCREWS AND HEx. NUTS
1) Install the 10 countersunk head screws (A) Fig.1 from underneath the
table as shown, then thread on the hex. nuts (B).
2) The hex. nuts (B) will act as leveling hardware for the Router Lift (mod.
XL-125) or the PhenolicRouter Insert Plate (mod. XL-114).
MOUNTING CAST-IRON TAbLE TO FLOOR STAND (MOD. xL-085)
1) Position the Cast-Iron Table (A) Fig.2 upside down (facing down) so the
underneath of the table is exposed.
2) Position the completely assembled Floor Stand (mod. XL-085) upside
down onto the table as shown. Make sure the front of the Floor Stand
faces the front of the Cast-Iron Table.
3) Align the 6 mounting holes in the Floor Stand with those of the Cast-Iron
Table, secure the Floor Stand to the Cast-Iron Table using 6 cap screws,
spring washers and washers (B).
FIGURE 1
FIGURE 2
